🗊Презентация Balers

BALERS HAY BALING AND BALERS THE BALER IN oPERATION

 HAY BALING AND BALERS  Speed is essential to good haymaking in order to con-serve the feed value of the crop. More hay can be baled in a given time with a pick-up baler than can be done with a stationary baler. Therefore the modern method of pick-up baling is found to be very valuable: it saves time and labour. Before commencing baling operations it is always advisable to check thoroughly the equipment to be used. This is very important-a breakdown with the baler can cause a serious loss in quality as well as quantity of the hay being baled.

Bcarings, shafts, chains and belts should examined for wear or damage and replaced or repaired before the haymaking season srarts. It is always advisable to check all machinery for wear and damage after each operation, and to order parts needed as soon as possible so as to have the machine in good working condition before it is required again. Bcarings, shafts, chains and belts should examined for wear or damage and replaced or repaired before the haymaking season srarts. It is always advisable to check all machinery for wear and damage after each operation, and to order parts needed as soon as possible so as to have the machine in good working condition before it is required again.

Most modern pick-up balers are driven by an engine mounted on the baler, or by the engine of the towing tractor. This method is known as power take-off. It is power achieved by means of a universal jointed coupling from the power take-off shaft of the tractor to the baler. Most modern pick-up balers are driven by an engine mounted on the baler, or by the engine of the towing tractor. This method is known as power take-off. It is power achieved by means of a universal jointed coupling from the power take-off shaft of the tractor to the baler.

THE BALER IN OPERATION Pick-up baling machines have adjustments to enable them to handle every type and condition of crop.An understanding of these adjustments will enable the operator to bale the crop with the minimum of delay.

As the baler moves around the field, a revolving drum, with steel fingers attached lifts the material up from the windrow on to an elevat ers attached ich either feeds the material direct to the bailing chamber or on to conveyor. The cross conveyor carries the material to the feed chamber, wher material is fed into the. Baling chamber in front of the ram which press bale. When the bale reaches the requircd ngth, usually about 3 ft a trip sets mechanism in operation which places the wire around th where it is tied automatic- ally. The action of the following bales force ticd bales out of the end of the baling chamber on to the ground. As the baler moves around the field, a revolving drum, with steel fingers attached lifts the material up from the windrow on to an elevat ers attached ich either feeds the material direct to the bailing chamber or on to conveyor. The cross conveyor carries the material to the feed chamber, wher material is fed into the. Baling chamber in front of the ram which press bale. When the bale reaches the requircd ngth, usually about 3 ft a trip sets mechanism in operation which places the wire around th where it is tied automatic- ally. The action of the following bales force ticd bales out of the end of the baling chamber on to the ground.

After the first two or three hours of use of a new baler, and also whe rting a new season with an old one, the corners of the baling chambe come obstructed with ch which is to be removed. To remove it, it isnecessary to loosen off the tension springs and remove all the hay baling chamber. After the first two or three hours of use of a new baler, and also whe rting a new season with an old one, the corners of the baling chambe come obstructed with ch which is to be removed. To remove it, it isnecessary to loosen off the tension springs and remove all the hay baling chamber.

Thank you for attention